Name: NETGEAR M4100 Series ProSAFE
Brand: NETGEAR
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Switching Commands

143

M4100 Series ProSAFE Managed Switches

Command example:

(NETGEAR Switch) #show ip dhcp snooping

DHCP snooping is Disabled

DHCP snooping source MAC verification is enabled

DHCP snooping is enabled on the following VLANs:

11 - 30, 40

Interface Trusted Log Invalid Pkts

--------- -------- ----------------

0/1 Yes No

0/2 No Yes

0/3 No Yes

0/4 No No

0/6 No No

show ip dhcp snooping binding

Use this command to display the DHCP Snooping binding entries. To restrict the output, use

the following options:

• Dynamic: Restrict the output based on DCHP snooping.

• Interface: Restrict the output based on a specific interface.

• Static: Restrict the output based on static entries.

• VLAN: Restrict the output based on VLAN.

Format show ip dhcp snooping binding [static | dynamic] [interface

<slot/port>] [<vlan id>]

Mode • Privileged EXEC

• User EXEC

Term Definition

MAC Address Displays the MAC address for the binding that was added. The MAC address is the key

to the binding database.

IP Address Displays the valid IP address for the binding rule.

VLAN The VLAN for the binding rule.

Interface The interface to add a binding into the DHCP snooping interface.

Type Binding type; statically configured from the CLI or dynamically learned.

Lease (sec) The remaining lease time for the entry.

Questions and Answers:

Need help?

Do you have a question about the NETGEAR M4100 Series ProSAFE and is the answer not in the manual?

NETGEAR M4100 Series ProSAFE Specifications

General