Routing Commands
241
M4100 Series ProSAFE Managed Switches
clear ip route counters
This command resets to zero the IPv4 routing table counters reported in the output of the
show ip route summary command. The command resets only the event counters.
Counters that report the current state of the routing table, such as the number of routes of
each type, are not reset.
show ip brief
This command displays all the summary information of the IP, including the ICMP rate limit
configuration and the global ICMP Redirect configuration.
• Privileged EXEC
• User EXEC
Protocol Tells which protocol added the specified route. The possibilities are: local, static, OSPF, or
RIP.
Total Number
of Routes
The total number of routes.
Format clear ip route counters
Mode Privileged EXEC
Format show ip brief
Modes
Term Definition
Default Time to Live The computed TTL (Time to Live) of forwarding a packet from the local router to the
final destination.
Routing Mode Shows whether the routing mode is enabled or disabled.
Maximum Next Hops The maximum number of next hops the packet can travel.
Maximum Routes The maximum number of routes the packet can travel.
ICMP Rate Limit
Interval
Shows how often the token bucket is initialized with burst-size tokens.
Burst-interval is from 0 to 2,147,483,647 milliseconds. The default burst-interval is
1000 msec.
ICMP Rate Limit Burst
Size
Shows the number of ICMPv4 error messages that can be sent during one
burst-interval. The range is from 1 to 200 messages. The default value is 100
messages.
ICMP Echo Replies Shows whether ICMP Echo Replies are enabled or disabled.
ICMP Redirects Shows whether ICMP Redirects are enabled or disabled.
To Next Page
Loading...
Need help?
General
