NETGEAR M4100 Series ProSAFE User Manual

Quality of Service Commands
304
M4100 Series ProSAFE Managed Switches
no acl-trapflags
This command disables the ACL trap mode.
show ip access-lists
This command displays an IP ACL <accesslistnumber> is the number used to identify
the IP ACL.
Note: Only the access list fields that you configure are displayed.
Format no acl-trapflags
Mode Global Config
Format show ip access-lists <accesslistnumber>
Mode Privileged EXEC
Term Definition
Rule Number The number identifier for each rule that is defined for the IP ACL.
Action The action associated with each rule. The possible values are Permit or Deny.
Match All Indicates whether this access list applies to every packet. Possible values are True or
False.
Protocol The protocol to filter for this rule.
Source IP
Address
The source IP address for this rule.
Source IP Mask The source IP Mask for this rule.
Source L4 Port
Keyword
The source port for this rule.
Destination IP
Address
The destination IP address for this rule.
Destination IP
Mask
The destination IP Mask for this rule.
Destination L4
Port Keyword
The destination port for this rule.
IP DSCP The value specified for IP DSCP.
IP Precedence The value specified IP Precedence.
IP TOS The value specified for IP TOS.

NETGEAR M4100 Series ProSAFE Specifications

General

Product Type	Managed Switch
Form Factor	Rack-mountable
Layer	Layer 2/Layer 3
Management	Web-based, CLI, SNMP
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1x
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	32°F to 122°F (0°C to 50°C)
Storage Temperature	-20° to 70° C (-4° to 158° F)
PoE Support	Yes (on select models)