NETGEAR M4100 Series ProSAFE User Manual

Routing Commands
260
M4100 Series ProSAFE Managed Switches
ICMP Throttling Commands
This section describes the commands you use to configure options for the transmission of
various types of ICMP messages.
ip unreachables
Use this command to enable the generation of ICMP Destination Unreachable messages. By
default, the generation of ICMP Destination Unreachable messages is enabled.
no ip unreachables
Use this command to prevent the generation of ICMP Destination Unreachable messages.
ip redirects
Use this command to enable the generation of ICMP Redirect messages by the router. By
default, the generation of ICMP Redirect messages is disabled.
• Global Config
• Interface Config
no ip redirects
Use this command to prevent the generation of ICMP Redirect messages by the router.
• Global Config
• Interface Config
Default enable
Format ip unreachables
Mode
Interface Config
Format no ip unreachables
Mode Interface Config
Default disabled
Format ip redirects
Mode
Format no ip redirects
Mode

NETGEAR M4100 Series ProSAFE Specifications

General

Product Type	Managed Switch
Form Factor	Rack-mountable
Layer	Layer 2/Layer 3
Management	Web-based, CLI, SNMP
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1x
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	32°F to 122°F (0°C to 50°C)
Storage Temperature	-20° to 70° C (-4° to 158° F)
PoE Support	Yes (on select models)