NETGEAR M4100 Series ProSAFE User Manual

Switching Commands
96
M4100 Series ProSAFE Managed Switches
dot1x supplicant timeout start-period
Use this command to configure the start period timer interval in seconds to wait for the EAP
identity request from the authenticator.
no dot1x supplicant timeout start-period
Use this command to set the start-period value to the default.
dot1x supplicant timeout held-period
Use this command to configure the held period timer interval in seconds to wait for the next
authentication on previous authentication fail.
no dot1x supplicant timeout held-period
Use this command to set the held-period value to the default value.
dot1x supplicant timeout auth-period
Use this command to configure the authentication period timer interval in seconds to wait for
the next EAP request challenge from the authenticator.
Default 30 seconds
Format dot1x supplicant timeout start-period <1-65535>
Mode Interface Config
Format no dot1x supplicant timeout start-period
Mode Interface Config
Default 30 seconds
Format dot1x supplicant timeout held-period <1-65535>
Mode Interface Config
Format no dot1x supplicant timeout held-period
Mode Interface Config
Default 30 seconds
Format dot1x supplicant timeout auth-period <1-65535>
Mode Interface Config

NETGEAR M4100 Series ProSAFE Specifications

General

Product Type	Managed Switch
Form Factor	Rack-mountable
Layer	Layer 2/Layer 3
Management	Web-based, CLI, SNMP
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1x
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	32°F to 122°F (0°C to 50°C)
Storage Temperature	-20° to 70° C (-4° to 158° F)
PoE Support	Yes (on select models)