NETGEAR M4100 Series ProSAFE User Manual

Switching Commands
37
M4100 Series ProSAFE Managed Switches
spanning-tree port mode all
This command sets the Administrative Switch Port State for all ports to enabled.
no spanning-tree port mode all
This command sets the Administrative Switch Port State for all ports to disabled.
spanning-tree edgeport all
This command specifies that every port is an Edge Port within the Common and Internal
Spanning Tree. This allows all ports to transition to Forwarding State without delay.
no spanning-tree edgeport all
This command disables Edge Port mode for all ports within the Common and Internal
Spanning Tree.
spanning-tree bpduforwarding
Normally a switch will not forward Spanning Tree Protocol (STP) BPDU packets if STP is
disabled. However, if in some network setup, the user wishes to forward BDPU packets
received from other network devices, this command can be used to enable the forwarding.
Default enabled
Format spanning-tree port mode all
Mode Global Config
Format no spanning-tree port mode all
Mode Global Config
Format spanning-tree edgeport all
Mode Global Config
Format no spanning-tree edgeport all
Mode Global Config
Default disabled
Format spanning-tree bpduforwarding
Mode Global Config

NETGEAR M4100 Series ProSAFE Specifications

General

Product Type	Managed Switch
Form Factor	Rack-mountable
Layer	Layer 2/Layer 3
Management	Web-based, CLI, SNMP
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1x
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	32°F to 122°F (0°C to 50°C)
Storage Temperature	-20° to 70° C (-4° to 158° F)
PoE Support	Yes (on select models)