Utility Commands
374
M4100 Series ProSAFE Managed Switches
write memory
Use this command to save running configuration changes to NVRAM so that the changes
you make will persist across a reboot. This command is the same as the copy
system:running config nvram:startup-config command.
<url> nvram:sslpem-dhweak Downloads an HTTP secure-server
certificate.
<url> nvram:sslpem-dhstrong Downloads an HTTP secure-server
certificate.
<url> nvram:sslpem-root Downloads an HTTP secure-server
certificate. For more information, see
Hypertext Transfer Protocol (HTTP)
Commands on page 460.
<url> nvram:sslpem-server Downloads an HTTP secure-server
certificate.
<url> nvram:startup-config Downloads the startup configuration file
to the system.
<url> nvram:license-key Download the license date to the
system.
<url> ias-users Downloads IAS users file by SFTP, SCP,
or TFTP.
<url> {image1 | image2} Download an image from the remote
server to either image. In a stacking
environment, the downloaded image is
distributed to the stack nodes.
{image1 | image2} <url> Upload either image to the remote
server.
image1 image2 Copy image1 to image2.
image2 image1 Copy image2 to image1.
Format write memory
Mode Privileged EXEC
Table 1. Parameters for the copy command (continued)
Source Destination Description