NETGEAR M4100 Series ProSAFE

Multicast VLAN Registration Commands
225
M4100 Series ProSAFE Managed Switches
Command example:
(NETGEAR Switch)#show mvr members 224.1.1.1
MVR Group IP Status Members
------------------ --------------- ---------------------
224.1.1.1 INACTIVE 0/1, 0/2, 0/3
show mvr interface
This command displays the MVR-enabled interfaces configuration.
The following table explains the output fields.
• active or inactive indicates whether the port is forwarding.
• inVLAN or notInVLAN indicates whether the port is part of any VLAN.
Command example:
(NETGEAR Switch)#show mvr interface
Port Type Status Immediate Leave
--------- --------------- --------------------- --------------------
0/9 RECEIVER ACTIVE/inVLAN DISABLED
Command example:
(NETGEAR Switch)#show mvr interface 0/9
Type: RECEIVER Status: ACTIVE Immediate Leave: DISABLED
Command example:
(NETGEAR Switch)#show mvr interface 0/23 members
235.0.0.1 STATIC ACTIVE
Command example:
(NETGEAR Switch)#show mvr interface 0/23 members vlan 12
235.0.0.1 STATIC ACTIVE
235.1.1.1 STATIC ACTIVE
Format show mvr interface [<interface-id> [members [vlan <vid>]]]
Mode Privileged EXEC
Field Description
Port Interface number
Type The MVR port type. It can be none, receiver, or source type.
Status The interface status. It consists of two characteristics:
Immediate Leave The state of immediate mode. It can be enabled or disabled.