Switching Commands
170
M4100 Series ProSAFE Managed Switches
no set mld fast-leave
Use this command to disable MLD Snooping fast-leave admin mode on a selected interface.
• Interface Config
• VLAN Mode
set mld groupmembership-interval
Use this command to set the MLD Group Membership Interval time on a VLAN, one interface
or all interfaces. The Group Membership Interval time is the amount of time in seconds that a
switch waits for a report from a particular group on a particular interface before deleting the
interface from the entry. This value must be greater than the MLDv2 Maximum Response
time value. The range is 2 to 3600 seconds.
• Interface Config
• Global Config
• VLAN Mode
no set groupmembership-interval
Use this command to set the MLDv2 Group Membership Interval time to the default value.
• Interface Config
• Global Config
• VLAN Mode
set mld maxresponse
Use this command to set the MLD Maximum Response time for the system, on a particular
interface or VLAN. The Maximum Response time is the amount of time in seconds that a
switch will wait after sending a query on an interface because it did not receive a report for a
particular group in that interface. This value must be less than the MLD Query Interval time
value. The range is 1–65 seconds.
• Global Config
• Interface Config
• VLAN Mode
Format no set mld fast-leave <vlan-id>
Mode
Default 260 seconds
Format set mld groupmembership-interval <vlan-id> <2-3600>
Mode
Format no set mld groupmembership-interval
Mode
Default 10 seconds
Format set mld maxresponse <1-65>
Mode
To Next Page
Loading...
Need help?
General
