Name: NETGEAR M4100 Series ProSAFE
Brand: NETGEAR
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Management Commands

444

M4100 Series ProSAFE Managed Switches

Switch Management CPU Commands

To manage the switch via the web GUI or telnet, an IP address needs to be assigned to the

switch management CPU. Whereas there are CLI commands that can be used to do this,

ezconfig simplifies the task. The tool allows you to configure the following parameters:

1. The administrator’s user password and administrator-enable password

2. Management CPU IP address and network mask

3. System name and location information

The tool is interactive and uses questions to guide you through the steps required to perform

its task. At the end of the session, it will ask you if you want to save the changed information.

To see exactly what has been changed by ezconfig at the end of the session, use the show

running-config command.

To perform any switch configuration other than the items listed above, use other CLI

commands or the web GUI.

ezconfig

This command sets the IP address, subnet mask, and gateway of the device. The IP address

and the gateway must be on the same subnet.

Format ezconfig

Mode Privileged EXEC

Questions and Answers:

Need help?

Do you have a question about the NETGEAR M4100 Series ProSAFE and is the answer not in the manual?

NETGEAR M4100 Series ProSAFE Specifications

General