NETGEAR M4100 Series ProSAFE User Manual

Switching Commands
138
M4100 Series ProSAFE Managed Switches
show dhcp client vendor-id-option
Use this command to display the configured administration mode of the vendor-id-option and
the vendor-id string to be included in Option-43 in DHCP requests.
Command example:
(NETGEAR Switch) #show dhcp client vendor-id-option
DHCP Client Vendor Identifier Option ........... Enabled
DHCP Client Vendor Identifier Option string .... Client
DHCP Snooping Configuration Commands
This section describes commands you use to configure DHCP Snooping.
ip dhcp snooping
Use this command to enable DHCP Snooping globally.
no ip dhcp snooping
Use this command to disable DHCP Snooping globally.
ip dhcp snooping vlan
Use this command to enable DHCP Snooping on a list of comma-separated VLAN ranges.
Format show dhcp client vendor-id-option
Mode Privileged EXEC
Default disabled
Format ip dhcp snooping
Mode Global Config
Format no ip dhcp snooping
Mode Global Config
Default disabled
Format ip dhcp snooping vlan <vlan-list>
Mode Global Config

NETGEAR M4100 Series ProSAFE Specifications

General

Product Type	Managed Switch
Form Factor	Rack-mountable
Layer	Layer 2/Layer 3
Management	Web-based, CLI, SNMP
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1x
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	32°F to 122°F (0°C to 50°C)
Storage Temperature	-20° to 70° C (-4° to 158° F)
PoE Support	Yes (on select models)