NETGEAR M4100 Series ProSAFE User Manual

Switching Commands
165
M4100 Series ProSAFE Managed Switches
set igmp querier query-interval
Use this command to set the IGMP Querier Query Interval time. It is the amount of time in
seconds that the switch waits before sending another general query.
no set igmp querier query-interval
Use this command to set the IGMP Querier Query Interval time to its default value.
set igmp querier timer expiry
Use this command to set the IGMP Querier timer expiration period. It is the time period that
the switch remains in Non-Querier mode once it has discovered that there is a Multicast
Querier in the network.
no set igmp querier timer expiry
Use this command to set the IGMP Querier timer expiration period to its default value.
set igmp querier version
Use this command to set the IGMP version of the query that the snooping switch is going to
send periodically.
Default disabled
Format set igmp querier query-interval <1-18000>
Mode Global Config
Format no set igmp querier query-interval
Mode Global Config
Default 60 seconds
Format set igmp querier timer expiry <60-300>
Mode Global Config
Format no set igmp querier timer expiry
Mode Global Config
Default 1
Format set igmp querier version <1-2>
Mode Global Config

NETGEAR M4100 Series ProSAFE Specifications

General

Product Type	Managed Switch
Form Factor	Rack-mountable
Layer	Layer 2/Layer 3
Management	Web-based, CLI, SNMP
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1x
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	32°F to 122°F (0°C to 50°C)
Storage Temperature	-20° to 70° C (-4° to 158° F)
PoE Support	Yes (on select models)