NETGEAR M4100 Series ProSAFE User Manual

Utility Commands
387
M4100 Series ProSAFE Managed Switches
no bootfile
This command deletes the boot image name.
domain-name (DHCP Pool Config)
This command specifies the domain name for a DHCP client. The <domain> argument
specifies the domain name string of the client.
no domain-name
This command removes the domain name.
netbios-name-server
This command configures NetBIOS Windows Internet Naming Service (WINS) name servers
that are available to DHCP clients.
One IP address is required, although one can specify up to eight addresses in one command
line. Servers are listed in order of preference (address1 is the most preferred server,
address2 is the next most preferred server, and so on).
no netbios-name-server
This command removes the NetBIOS name server list.
Format no bootfile
Mode DHCP Pool Config
Default none
Format domain-name <domain>
Mode DHCP Pool Config
Format no domain-name
Mode DHCP Pool Config
Default none
Format netbios-name-server <address> [<address2>...<address8>]
Mode DHCP Pool Config
Format no netbios-name-server
Mode DHCP Pool Config

NETGEAR M4100 Series ProSAFE Specifications

General

Product Type	Managed Switch
Form Factor	Rack-mountable
Layer	Layer 2/Layer 3
Management	Web-based, CLI, SNMP
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1x
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	32°F to 122°F (0°C to 50°C)
Storage Temperature	-20° to 70° C (-4° to 158° F)
PoE Support	Yes (on select models)