NETGEAR M4100 Series ProSAFE

Switching Commands
116
M4100 Series ProSAFE Managed Switches
lacp partner port id
Use this command to configure the LACP partner port id. The valid range for <port-id> is
0–65535.
Note: This command is only applicable to physical interfaces.
no lacp partner port id
Use this command to set the LACP partner port id to the default.
lacp partner port priority
Use this command to configure the LACP partner port priority. The valid range for
<priority> is 0–255.
Note: This command is only applicable to physical interfaces.
no lacp partner port priority
Use this command to configure the default LACP partner port priority.
Default 0x80
Format lacp partner portid <port-id>
Mode Interface Config
Format no lacp partner portid
Mode Interface Config
Default 0x0
Format lacp partner port priority <priority>
Mode Interface Config
Format no lacp partner port priority
Mode Interface Config