Management Commands
448
M4100 Series ProSAFE Managed Switches
show network
Use this command to display configuration settings associated with the switch’s network
interface. The network interface is the logical interface used for in-band connectivity with the
switch via any of the switch's front panel ports. The configuration parameters associated with
the switch's network interface do not affect the configuration of the front panel ports through
which traffic is switched or routed. The network interface is always considered to be up,
whether any member ports are up; therefore, the show network command will always show
“Interface Status” as “up”.
• Privileged EXEC
• User EXEC
Format show network
Modes
Term Definition
Interface Status The network interface status; it is always considered to be “up”.
IP Address The IP address of the interface. The factory default value is 0.0.0.0.
Subnet Mask The IP subnet mask for this interface. The factory default value is 0.0.0.0.
Default Gateway The default gateway for this IP interface. The factory default value is 0.0.0.0.
IPv6
Administrative
Mode
Whether enabled or disabled.
IPv6
Address/Length
The IPv6 address and length.
IPv6 Default
Router
The IPv6 default router address.
Burned In MAC
Address
The burned in MAC address used for in-band connectivity.
Locally
Administered
MAC Address
If desired, a locally administered MAC address can be configured for in-band
connectivity. To take effect, 'MAC Address Type' must be set to 'Locally Administered'.
Enter the address as twelve hexadecimal digits (6 bytes) with a colon between each
byte. Bit 1 of byte 0 must be set to a 1 and bit 0 to a 0, that is, byte 0 should have the
following mask “xxxx xx10”. The MAC address used by this bridge when it must be
referred to in a unique fashion. It is recommended that this be the numerically smallest
MAC address of all ports that belong to this bridge. However it is only required to be
unique. When concatenated with dot1dStpPriority a unique BridgeIdentifier is formed
which is used in the Spanning Tree Protocol.
MAC Address
Type
The MAC address which should be used for in-band connectivity. The choices are the
burned in or the Locally Administered address. The factory default is to use the burned in
MAC address.
To Next Page
Loading...
Need help?
General
