NETGEAR M4100 Series ProSAFE

Switching Commands
141
M4100 Series ProSAFE Managed Switches
ip dhcp snooping limit
Use this command to control the rate at which the DHCP Snooping messages come. The
default rate is 15 pps with a range from 0 to 30 pps. The default burst level is 1 second with a
range of 1–15 seconds.
no ip dhcp snooping limit
Use this command to set the rate at which the DHCP Snooping messages come, and the
burst level, to the defaults.
ip dhcp snooping log-invalid
Use this command to control the logging DHCP messages filtration by the DHCP Snooping
application.
no ip dhcp snooping log-invalid
Use this command to disable the logging DHCP messages filtration by the DHCP Snooping
application.
ip dhcp snooping trust
Use this command to configure the port as trusted.
Default 15 pps for rate limiting and 1 sec for burst interval
Format ip dhcp snooping limit {rate <pps> [burst interval <seconds>]}
Mode Interface Config
Format no ip dhcp snooping limit
Mode Interface Config
Default disabled
Format ip dhcp snooping log-invalid
Mode Interface Config
Format no ip dhcp snooping log-invalid
Mode Interface Config
Default disabled
Format ip dhcp snooping trust
Mode Interface Config