NETGEAR M4100 Series ProSAFE User Manual

Switching Commands
102
M4100 Series ProSAFE Managed Switches
no storm-control multicast rate
This command sets the multicast storm recovery threshold to the default value for an
interface and disables multicast storm recovery.
storm-control multicast (Global Config)
This command enables multicast storm recovery mode for all interfaces. If the mode is
enabled, multicast storm recovery is active, and if the rate of L2 multicast traffic ingressing on
an interface increases beyond the configured threshold, the traffic will be dropped. Therefore,
the rate of multicast traffic will be limited to the configured threshold.
no storm-control multicast
This command disables multicast storm recovery mode for all interfaces.
storm-control multicast level (Global Config)
This command configures the multicast storm recovery threshold for all interfaces as a
percentage of link speed and enables multicast storm recovery mode. If the mode is enabled,
multicast storm recovery is active, and if the rate of L2 multicast traffic ingressing on an
interface increases beyond the configured threshold, the traffic will be dropped. Therefore,
the rate of multicast traffic will be limited to the configured threshold.
Default 0
Format storm-control multicast rate <0-14880000>
Mode Interface Config
Format no storm-control multicast rate
Mode Interface Config
Default disabled
Format storm-control multicast
Mode Global Config
Format no storm-control multicast
Mode Global Config
Default 5
Format storm-control multicast level <0-100>
Mode Global Config

NETGEAR M4100 Series ProSAFE Specifications

General

Product Type	Managed Switch
Form Factor	Rack-mountable
Layer	Layer 2/Layer 3
Management	Web-based, CLI, SNMP
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1x
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	32°F to 122°F (0°C to 50°C)
Storage Temperature	-20° to 70° C (-4° to 158° F)
PoE Support	Yes (on select models)