Management Commands
449
M4100 Series ProSAFE Managed Switches
Command example:
This output is for the network port:
(NETGEAR Switch) #show network
Interface Status............................... Always Up
IP Address..................................... 10.250.3.1
Subnet Mask.................................... 255.255.255.0
Default Gateway................................ 10.250.3.3
IPv6 Administrative Mode....................... Enabled
IPv6 Address/Length is ........................ FE80::210:18FF:FE82:337/64
IPv6 Address/Length is ........................ 3099::1/64
IPv6 Address/Length is ........................ 3099::210:18FF:FE82:337/64
IPv6 Default Router is ........................ FE80::204:76FF:FE73:423A
Burned In MAC Address.......................... 00:10:18:82:03:37
Locally Administered MAC Address............... 00:00:00:00:00:00
MAC Address Type............................... Burned In
Network Configuration Protocol Current......... None
Management VLAN ID............................. 1
Web Mode....................................... Enable
Java Mode...................................... Enable
Console Port Access Commands
This section describes the commands you use to configure the console port. You can use a
serial cable to connect a management host directly to the console port of the switch.
configuration
Use this command to access Global Config mode. From Global Config mode, you can
configure various system settings, including user accounts. You can also enter other
command modes, including Line Config mode.
line
Use this command to access Line Config mode, which allows you to configure various Telnet
settings, ssh settings, and the console port.
Format configuration
Mode Privileged EXEC
Format line {console | telnet | ssh}
Mode Global Config
To Next Page
Loading...
Need help?
General
