Utility Commands
356
M4100 Series ProSAFE Managed Switches
show logging
This command displays logging configuration information.
Format logging syslog source-interface {<slot/port> | {loopback
<loopback-id>} | {vlan <vlan-id>}}
Mode Global Config
Parameter Description
<slot/port> VLAN or port-based routing interface.
loopback
<loopback-id>
Configures the loopback interface to use as the source IP address. The range of
the loopback ID is 0 to 7.
vlan <vlan-id> Configures the VLAN interface to use as the source IP address. The range of the
VLAN ID is 1 to 4093.
Format show logging
Mode Privileged EXEC
Term Definition
Logging Client
Local Port
The port on the collector/relay to which syslog messages are sent.
CLI Command
Logging
Shows whether CLI Command logging is enabled.
Console Logging Shows whether console logging is enabled.
Console Logging
Severity Filter
The minimum severity to log to the console log. Messages with an equal or lower
numerical severity are logged.
Buffered Logging Shows whether buffered logging is enabled.
Syslog Logging Shows whether syslog logging is enabled.
Log Messages
Received
Number of messages received by the log process. This includes messages that are
dropped or ignored.
Log Messages
Dropped
Number of messages that could not be processed due to error or lack of resources.
Log Messages
Relayed
Number of messages sent to the collector/relay.
To Next Page
Loading...
Need help?
General
