Name: NETGEAR M4100 Series ProSAFE
Brand: NETGEAR
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Routing Commands

240

M4100 Series ProSAFE Managed Switches

OSPF advertises the IP MTU in the Database Description packets it sends to its neighbors

during database exchange. If two OSPF neighbors advertise different IP MTUs, they will not

form an adjacency. (unless OSPF has been instructed to ignore differences in IP MTU with

the ip ospf mtu-ignore command.)

Note: The IP MTU size refers to the maximum size of the IP packet (IP

Header + IP payload). It does not include any extra bytes that might

be required for Layer-2 headers. To receive and process packets, the

Ethernet MTU must take into account the size of the Ethernet header.

no ip mtu

This command resets the IP MTU to the default value.

encapsulation

This command configures the link layer encapsulation type for the packet. The encapsulation

type can be ethernet or snap.

Note: Routed frames are always Ethernet encapsulated when a frame is

routed to a VLAN.

clear ip route all

This command removes all the route entries learned over the network.

Default 1500 bytes

Format ip mtu <68-9198>

Mode Interface Config

Format no ip mtu

Mode Interface Config

Default ethernet

Format encapsulation {ethernet | snap}

Mode Interface Config

Format clear ip route all

Mode Privileged EXEC

Questions and Answers:

Need help?

Do you have a question about the NETGEAR M4100 Series ProSAFE and is the answer not in the manual?

NETGEAR M4100 Series ProSAFE Specifications

General