NETGEAR M4100 Series ProSAFE User Manual

Management Commands
457
M4100 Series ProSAFE Managed Switches
Secure Shell (SSH) Commands
This section describes the commands you use to configure SSH access to the switch. Use
SSH to access the switch from a remote management host.
Note: The system allows a maximum of five SSH sessions.
ip ssh
Use this command to enable SSH access to the system. (This command is the short form of
the ip ssh server enable command.)
ip ssh protocol
Use this command to set or remove protocol levels (or versions) for SSH. Either SSH1 (1),
SSH2 (2), or both SSH 1 and SSH 2 (1 and 2) can be set.
ip ssh server enable
Use this command to enable the IP secure shell server.
no ip ssh server enable
Use this command to disable the IP secure shell server.
Default disabled
Format ip ssh
Mode Privileged EXEC
Default 1 and 2
Format ip ssh protocol [1] [2]
Mode Privileged EXEC
Default disabled
Format ip ssh server enable
Mode Privileged EXEC
Format no ip ssh server enable
Mode Privileged EXEC

NETGEAR M4100 Series ProSAFE Specifications

General

Product Type	Managed Switch
Form Factor	Rack-mountable
Layer	Layer 2/Layer 3
Management	Web-based, CLI, SNMP
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1x
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	32°F to 122°F (0°C to 50°C)
Storage Temperature	-20° to 70° C (-4° to 158° F)
PoE Support	Yes (on select models)