NETGEAR M4100 Series ProSAFE User Manual

Switching Commands
210
M4100 Series ProSAFE Managed Switches
no dos-control icmpfrag
This command disabled ICMP Fragment Denial of Service protection.
show dos-control
This command displays Denial of Service configuration information.
Note: Not all messages below might be displayed for the M4100 series
switches.
Default disabled
Format dos-control icmpfrag
Mode Global Config
Format no dos-control icmpfrag
Mode Global Config
Format show dos-control
Mode Privileged EXEC
Term Definition
First Fragment
Mode
May be enabled or disabled. The factory default is disabled.
Min TCP Hdr
Size <0-255>
The factory default is 20.
ICMP Mode May be enabled or disabled. The factory default is disabled.
Max ICMPv4 Pkt
Size
The range is 0-1023. The factory default is 512.
Max ICMPv6 Pkt
Size
The range is 0-16384. The factory default is 512.
ICMP Fragment
Mode
May be enabled or disabled. The factory default is disabled.
L4 Port Mode May be enabled or disabled. The factory default is disabled.
TCP Port Mode May be enabled or disabled. The factory default is disabled.
UDP Port Mode May be enabled or disabled. The factory default is disabled.
SIPDIP Mode May be enabled or disabled. The factory default is disabled.

NETGEAR M4100 Series ProSAFE Specifications

General

Product Type	Managed Switch
Form Factor	Rack-mountable
Layer	Layer 2/Layer 3
Management	Web-based, CLI, SNMP
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1x
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	32°F to 122°F (0°C to 50°C)
Storage Temperature	-20° to 70° C (-4° to 158° F)
PoE Support	Yes (on select models)