NETGEAR M4100 Series ProSAFE User Manual

Switching Commands
95
M4100 Series ProSAFE Managed Switches
no dot1x supplicant port-control
Use this command to set the port-control mode to the default, auto.
dot1x supplicant max-start
Use this command to configure the number of attempts that the supplicant makes to find the
authenticator before the supplicant assumes that there is no authenticator.
no dot1x supplicant max-start
Use this command to set the max-start value to the default.
Format dot1x supplicant port-control {auto | force-authorized |
force_unauthorized}
Mode Interface Config
Parameter Description
auto The port is in the Unauthorized state until it presents its user name and
password credentials to an authenticator. If the authenticator authorizes the
port, then it is placed in the Authorized state.
force-authorized Sets the authorization state of the port to Authorized, bypassing the
authentication process.
force- unauthorized Sets the authorization state of the port to Unauthorized, bypassing the
authentication process.
Default Auto
Format no dot1x supplicant port-control
Mode Interface Config
Default 3
Format dot1x supplicant max-start <1-10>
Mode Interface Config
Format no dot1x supplicant max-start
Mode Interface Config

NETGEAR M4100 Series ProSAFE Specifications

General

Product Type	Managed Switch
Form Factor	Rack-mountable
Layer	Layer 2/Layer 3
Management	Web-based, CLI, SNMP
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1x
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	32°F to 122°F (0°C to 50°C)
Storage Temperature	-20° to 70° C (-4° to 158° F)
PoE Support	Yes (on select models)