Switching Commands
101
M4100 Series ProSAFE Managed Switches
storm-control multicast (Interface Config)
This command enables multicast storm recovery mode for an interface. If the mode is
enabled, multicast storm recovery is active, and if the rate of L2 multicast traffic ingressing on
an interface increases beyond the configured threshold, the traffic will be dropped. Therefore,
the rate of multicast traffic will be limited to the configured threshold.
no storm-control multicast
This command disables multicast storm recovery mode for an interface.
storm-control multicast level (Interface Config)
This command configures the multicast storm recovery threshold for an interface as a
percentage of link speed and enables multicast storm recovery mode. If the mode is enabled,
multicast storm recovery is active, and if the rate of L2 multicast traffic ingressing on an
interface increases beyond the configured threshold, the traffic will be dropped. Therefore,
the rate of multicast traffic will be limited to the configured threshold.
no storm-control multicast level
This command sets the multicast storm recovery threshold to the default value for an
interface and disables multicast storm recovery.
storm-control multicast rate (Interface Config)
Use this command to configure the multicast storm recovery threshold for an interface in
packets per second. If the mode is enabled, multicast storm recovery is active, and if the rate
of L2 broadcast traffic ingressing on an interface increases beyond the configured threshold,
the traffic is dropped. Therefore, the rate of multicast traffic is limited to the configured
threshold.
Default disabled
Format storm-control multicast
Mode Interface Config
Format no storm-control multicast
Mode Interface Config
Default 5
Format storm-control multicast level <0-100>
Mode Interface Config
Format no storm-control multicast level <0-100>
Mode Interface Config
To Next Page
Loading...
Need help?
General
