NETGEAR M4100 Series ProSAFE

Switching Commands
108
M4100 Series ProSAFE Managed Switches
no flowcontrol
• Global Config
• Interface Config
show flowcontrol
Use this command to display the IEEE 802.3 Annex 31B flow control settings and status for a
specific interface or all interfaces. It also displays 802.3 Tx and Rx pause counts. Priority
Flow Control frames counts are not displayed. If the port is enabled for priority flow control,
operational flow control status is displayed as “Inactive”. Operational flow control status for
stacking ports is always displayed as “N/A”.
Command example:
(NETGEAR Switch)#show flowcontrol
Admin Flow Control: Symmetric
Port Flow Control RxPause TxPause
Oper
------ ------------ -------- ---------
0/1 Active 310 611
0/2 Inactive 0 0
Command example:
(NETGEAR Switch)#show flowcontrol interface 0/1
Admin Flow Control: Symmetric
Port Flow Control RxPause TxPause
Oper
--------- ------- -------- -------
0/1 Active 310 611
Format no flowcontrol
Mode
Format show flowcontrol [slot/port]
Mode
Privileged Exec