Routing Commands
243
M4100 Series ProSAFE Managed Switches
Command example:
(NETGEAR Switch) >show ip interface 0/2
Routing Interface Status....................... Down
Method......................................... None
Routing Mode................................... Disable
Administrative Mode............................ Enable
Forward Net Directed Broadcasts................ Disable
Proxy ARP...................................... Enable
Local Proxy ARP................................ Disable
Active State................................... Inactive
Link Speed Data Rate........................... Inactive
MAC address.................................... 02:14:6C:FF:00:DE
Encapsulation Type............................. Ethernet
IP MTU......................................... 1500
Bandwidth...................................... 100000 kbps
Destination Unreachables....................... Enabled
ICMP Redirects................................. Disabled
show ip interface brief
This command displays summary information about IP configuration settings for all ports in
the router.
• Privileged EXEC
• User EXEC
Link Speed Data
Rate
An integer representing the physical link data rate of the specified interface.
This is
measured in Megabits per second (Mbps).
MAC Address The burned in physical address of the specified interface. The format is 6 two-digit
hexadecimal numbers that are separated by colons.
Encapsulation
Type
The encapsulation type for the specified interface. The types are: Ethernet or SNAP.
IP MTU The maximum transmission unit (MTU) size of a frame, in bytes.
Bandwidth Shows the bandwidth of the interface.
Destination
Unreachables
Displays whether ICMP Destination Unreachables might be sent (enabled or disabled).
ICMP Redirects Displays whether ICMP Redirects might be sent (enabled or disabled).
Format show ip interface brief
Modes
Term Definition
To Next Page
Loading...
Need help?
General
