NETGEAR M4100 Series ProSAFE

Switching Commands
140
M4100 Series ProSAFE Managed Switches
no ip dhcp snooping database write-delay
Use this command to set the write delay value to the default value.
ip dhcp snooping binding
Use this command to configure static DHCP Snooping binding.
no ip dhcp snooping binding <mac-address>
Use this command to remove the DHCP static entry from the DHCP Snooping database.
ip verify binding
Use this command to configure static IP source guard (IPSG) entries.
no ip verify binding
Use this command to remove the IPSG static entry from the IPSG database.
Format no ip dhcp snooping database write-delay
Mode Global Config
Format ip dhcp snooping binding <mac-address> vlan <vlan id> <ip address>
interface <slot/port>
Mode Global Config
Format no ip dhcp snooping binding <mac-address>
Mode Global Config
Format ip verify binding <mac-address> vlan <vlan id> <ip address>
interface <slot/port>
Mode Global Config
Format no ip verify binding <mac-address> vlan <vlan id> <ip address>
interface <slot/port>
Mode Global Config