NETGEAR M4100 Series ProSAFE

Power over Ethernet Commands
327
M4100 Series ProSAFE Managed Switches
Command example:
(NETGEAR Switch) #show poe port info 0/33
High Max Output Output
Intf Power Power Class Power Current Voltage Status Fault
(W) (W) (mA) (volt) Status
------ ------- ----- ------- ------ ------- ------- ------------------ --------
0/33 No 18.0 2 04.400 84 53.3 Delivering Power No Error
show poe pd
Note: This command is supported on the M4100-D12G-POE+ (GSM5212P)
only.
Use this command to get information about the PD ports. You can display information based
on each individual port or all the PD ports collectively
.
• Privileged EXEC
• User EXEC
• 1-event—PSE detects the PD in 1-event mode (802.1f)
• 2-event—PSE detects the PD in 2-event mode (802.1at)
• LLDP—PSE detects the PD in LLDP mode (802.1at)
• Powered—Receiving power from PSE
• Off—No power from the PSE (when main
AC is in used)
Command example:
(NETGEAR Switch) #show poe pd all
Intf Mode Class Detection Mode Status
---- ----- --------- ---------------- ----------
0/1 PD class 4 2-event powered
0/2 PD class 4 LLDP powered
Format show poe pd [<port> | all]
Mode
Term Definition
Intf Show the PD device interface number, only 0/1 or 0/2 on the GSM5212P.
In other devices, the table is empty. If <port-id> is not specified, all PD
ports are displayed.
Mode Displays the port POE role and is always PD.
Class Displays the POE class.
Detection Mode PD detection mode when getting power from the PSE:
Status Shows whether the port 0/1 or 0/2 is providing power: