NETGEAR M4100 Series ProSAFE

Utility Commands
369
M4100 Series ProSAFE Managed Switches
enable password
This command prompts you to change the Privileged EXEC password. Passwords are a
maximum of 64 alphanumeric characters. The password is case-sensitive. The encrypted
option allows you to transfer the enable password between devices without needing to know
the password. In this case, the <password> parameter must be exactly 128 hexadecimal
characters.
logout
This command closes the current telnet connection or resets the current serial connection.
Note: Save configuration changes before logging out.
• Privileged EXEC
• User EXEC
ping
Use this command to determine whether another computer is on the network. Ping provides
a synchronous response when initiated from the CLI and web interfaces.
• The default count is 1.
• The default interval is 3 seconds.
• The default size is 0 bytes.
• Privileged EXEC
• User EXEC
Using the options described below, you can specify the number and size of Echo Requests
and the interval between Echo Requests.
Format enable password <password> [encrypted]
Mode Privileged EXEC
Format logout
Modes
Default
Format ping {<ipaddress> | <hostname>} [count <count>] [interval
<interval>] [size <size>]
Modes
Parameter Description
[count <count>] As an option, specify the number of ping packets (ICMP Echo requests) that
are sent to the destination address. The range is 1–15 requests.