NETGEAR M4100 Series ProSAFE

Utility Commands
376
M4100 Series ProSAFE Managed Switches
sntp client port
This command sets the SNTP client port id to a value from 1-65,535.
no sntp client port
This command resets the SNTP client port back to its default value.
sntp unicast client poll-interval
This command sets the poll interval for SNTP unicast clients in seconds as a power of two
where <poll-interval> can be a value from 6 to 10.
no sntp unicast client poll-interval
This command resets the poll interval for SNTP unicast clients to its default value.
sntp unicast client poll-timeout
This command will set the poll timeout for SNTP unicast clients in seconds to a value from
1-30.
Default 123
Format sntp client port <portid>
Mode Global Config
Format no sntp client port
Mode Global Config
Default 6
Format sntp unicast client poll-interval <poll-interval>
Mode Global Config
Format no sntp unicast client poll-interval
Mode Global Config
Default 5
Format sntp unicast client poll-timeout <poll-timeout>
Mode Global Config