Management Commands
514
M4100 Series ProSAFE Managed Switches
Access Accepts................................ 0
Access Rejects................................ 0
Access Challenges............................. 0
Malformed Access Responses.................... 0
Bad Authenticators............................ 0
Pending Requests.............................. 0
Timeouts...................................... 0
Unknown Types................................. 0
Packets Dropped............................... 0
TACACS+ Commands
TACACS+ provides access control for networked devices via one or more centralized
servers. Similar to RADIUS, this protocol simplifies authentication by making use of a single
database that can be shared by many clients on a large network. TACACS+ is based on the
TACACS protocol (described in RFC1492) but additionally provides for separate
authentication, authorization, and accounting services. The original protocol was UDP based
with messages passed in clear text over the network. TACACS+ uses TCP to ensure reliable
delivery and a shared key configured on the client and daemon server to encrypt all
messages.
debug tacacs packet
Use this command to enable TACACS+ packet debugging.
no debug tacacs packet
Use this command to disable TACACS+ packet debugging.
tacacs-server host
Use this command to configure a TACACS+ server. This command enters into the TACACS+
configuration mode. The <ip-address> or <hostname> parameter is the IP address or
host name of the TACACS+ server. To specify multiple hosts, repeat this command.
Default Disabled
Format debug tacacs packet [receive | transmit]
Mode Global Config
Format no debug tacacs packet
Mode Global Config
Format tacacs-server host {<ip-address> | <hostname>}
Mode Global Config
To Next Page
Loading...
Need help?
General
