Name: NETGEAR M4100 Series ProSAFE
Brand: NETGEAR
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Switching Commands

M4100 Series ProSAFE Managed Switches

If 0 (defined as the default CIST ID) is passed as the <mstid>, this command sets the

Bridge Priority parameter for the Common and Internal Spanning Tree to the default value.

spanning-tree mst vlan

This command adds an association between a multiple spanning tree instance and one or

more VLANs so that the VLAN(s) are no longer associated with the Common and Internal

Spanning Tree. The parameter <mstid> is a number that corresponds to the desired

existing multiple spanning tree instance. The vlan range can be specified as a list or as a

range of values. To specify a list of VLANs, enter a list of VLAN IDs, each separated by a

comma with no spaces in between. To specify a range of VLANs, separate the beginning and

ending VLAN ID with a dash ("-").

no spanning-tree mst vlan

This command removes an association between a multiple spanning tree instance and one

or more VLANs so that the VLAN(s) are again associated with the Common and Internal

Spanning Tree.

spanning-tree port mode

This command sets the Administrative Switch Port State for this port to enabled.

no spanning-tree port mode

This command sets the Administrative Switch Port State for this port to disabled.

Format no spanning-tree mst priority <mstid>

Mode Global Config

Format spanning-tree mst vlan <mstid> <vlanid>

Mode Global Config

Format no spanning-tree mst vlan <mstid> <vlanid>

Mode Global Config

Default enabled

Format spanning-tree port mode

Mode Interface Config

Format no spanning-tree port mode

Mode Interface Config

Questions and Answers:

Need help?

Do you have a question about the NETGEAR M4100 Series ProSAFE and is the answer not in the manual?

NETGEAR M4100 Series ProSAFE Specifications

General