Switching Commands
103
M4100 Series ProSAFE Managed Switches
no storm-control multicast level
This command sets the multicast storm recovery threshold to the default value for all
interfaces and disables multicast storm recovery.
storm-control multicast rate (Global Config)
Use this command to configure the multicast storm recovery threshold for all interfaces in
packets per second. If the mode is enabled, multicast storm recovery is active, and if the rate
of L2 broadcast traffic ingressing on an interface increases beyond the configured threshold,
the traffic is dropped. Therefore, the rate of multicast traffic is limited to the configured
threshold.
no storm-control broadcast rate
This command sets the broadcast storm recovery threshold to the default value for all
interfaces and disables broadcast storm recovery.
storm-control unicast (Interface Config)
This command enables unicast storm recovery mode for an interface. If the mode is enabled,
unicast storm recovery is active, and if the rate of unknown L2 unicast (destination lookup
failure) traffic ingressing on an interface increases beyond the configured threshold, the
traffic will be dropped. Therefore, the rate of unknown unicast traffic will be limited to the
configured threshold.
Format no storm-control multicast level
Mode Global Config
Default 0
Format storm-control multicast rate <0-14880000>
Mode Global Config
Format no storm-control broadcast rate
Mode Global Config
Default disabled
Format storm-control unicast
Mode Interface Config
To Next Page
Loading...
Need help?
General
