NETGEAR M4100 Series ProSAFE User Manual

Management Commands
454
M4100 Series ProSAFE Managed Switches
session-limit
Use this command to specify the maximum number of simultaneous outbound Telnet
sessions. A value of 0 indicates that no outbound Telnet session can be established.
no session-limit
Use this command to set the maximum number of simultaneous outbound Telnet sessions to
the default value.
session-timeout
Use this command to set the Telnet session timeout value. The timeout value unit of time is
minutes.
no session-timeout
Use this command to set the Telnet session timeout value to the default. The timeout value
unit of time is minutes.
telnetcon maxsessions
Use this command to specify the maximum number of Telnet connection sessions that can
be established. A value of 0 indicates that no Telnet connection can be established. The
range is 0-5.
Default 5
Format session-limit <0-5>
Mode Line Config
Format no session-limit
Mode Line Config
Default 5
Format session-timeout <1-160>
Mode Line Config
Format no session-timeout
Mode Line Config
Default 4
Format telnetcon maxsessions <0-4>
Mode Privileged EXEC

NETGEAR M4100 Series ProSAFE Specifications

General

Product Type	Managed Switch
Form Factor	Rack-mountable
Layer	Layer 2/Layer 3
Management	Web-based, CLI, SNMP
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1x
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	32°F to 122°F (0°C to 50°C)
Storage Temperature	-20° to 70° C (-4° to 158° F)
PoE Support	Yes (on select models)