NETGEAR M4100 Series ProSAFE

Switching Commands
185
M4100 Series ProSAFE Managed Switches
no lldp notification
Use this command to disable notifications.
lldp notification-interval
Use this command to configure how frequently the system sends remote data change
notifications. The <interval> parameter is the number of seconds to wait between sending
notifications. The valid interval range is 5-3600 seconds.
no lldp notification-interval
Use this command to return the notification interval to the default value.
clear lldp statistics
Use this command to reset all LLDP statistics, including MED-related information.
clear lldp remote-data
Use this command to delete all information from the LLDP remote data table, including
MED-related information.
Default disabled
Format no lldp notification
Mode Interface Config
Default 5
Format lldp notification-interval <interval>
Mode Global Config
Format no lldp notification-interval
Mode Global Config
Format clear lldp statistics
Mode Privileged Exec
Format clear lldp remote-data
Mode Global Config