Utility Commands
396
M4100 Series ProSAFE Managed Switches
no ip domain name
Use this command to remove the default domain name configured using the ip domain
name command.
ip domain list
Use this command to define a list of default domain names to complete unqualified names.
By default, the list is empty. Each name must be no more than 256 characters, and should
not include an initial period. The default domain name, configured using the ip domain
name command, is used only when the default domain name list is empty. A maximum of
32
names can be entered in to this list.
no ip domain list
Use this command to delete a name from a list.
ip name server
Use this command to configure the available name servers. Up to eight servers can be
defined in one command or by using multiple commands. The parameter
<server-address> is a valid IPv4 or IPv6 address of the server. The preference of the
servers is determined by the order they were entered.
no ip name server
Use this command to remove a name server.
Format no ip domain name
Mode Global Config
Default none
Format ip domain list <name>
Mode Global Config
Format no ip domain list <name>
Mode Global Config
Format ip name-server <server-address1>
[<server-address2>...<server-address8>]
Mode Global Config
Format no ip name-server [<server-address1>...<server-address8>]
Mode Global Config
To Next Page
Loading...
Need help?
General
