NETGEAR M4100 Series ProSAFE User Manual

Management Commands
506
M4100 Series ProSAFE Managed Switches
radius server retransmit
Use this command to configure the global parameter for the RADIUS client that specifies the
number of transmissions of the messages to be made before attempting the fall back server
upon unsuccessful communication with the current RADIUS authenticating server. When the
maximum number of retries are exhausted for the RADIUS accounting server and no
response is received, the client does not communicate with any other server.
no radius server retransmit
Use this command to set the value of this global parameter to the default value.
radius server timeout
Use this command to configure the global parameter for the RADIUS client that specifies the
time-out value (in seconds) after which a request must be retransmitted to the RADIUS
server if no response is received. The time-out value is an integer in the range of 1–30
seconds.
Parameter Description
<ipaddr> The IP address of the RADIUS Authenticating server.
<dnsname> The DNS name of the server.
Default 4
Format radius server retransmit <retries>
Mode Global Config
Parameter Description
<retries> The maximum number of transmission attempts in the range of 1–15.
Format no radius server retransmit
Mode Global Config
Default 5
Format radius server timeout <seconds>
Mode Global Config

NETGEAR M4100 Series ProSAFE Specifications

General

Product Type	Managed Switch
Form Factor	Rack-mountable
Layer	Layer 2/Layer 3
Management	Web-based, CLI, SNMP
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1x
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	32°F to 122°F (0°C to 50°C)
Storage Temperature	-20° to 70° C (-4° to 158° F)
PoE Support	Yes (on select models)