Utility Commands
363
M4100 Series ProSAFE Managed Switches
clear logging email statistics
This command resets the email alerting statistics.
mail-server
Use this command to configure the SMTP server to which the switch sends email alert
messages and change the mode to Mail Server Configuration mode. The server address can
be in the IPv4, IPv6, or DNS name format.
no mail-server
Use this command to remove the specified SMTP server from the configuration.
security (Mail Server Config)
Use this command to set the email alerting security protocol by enabling the switch to use
TLS authentication with the SMTP Server. If the TLS mode is enabled on the switch but the
SMTP server does not support TLS mode, no email is sent to the SMTP server.
No of Email Sent The number of email messages that were sent from the switch since the
counter was cleared.
Time Since Last Email
Sent
The amount of time that has passed since the last email was sent from the
switch.
Format clear logging email statistics
Mode Privileged EXEC
Format mail-server {<ip-address> | <ipv6-address> | <hostname>}
Mode Global Config
Format no mail-server {<ip-address> | <ipv6-address> | <hostname>}
Mode Global Config
Default none
Format security {tlsv1 | none}
Mode Mail Server Config
Term Definition
To Next Page
Loading...
Need help?
General
