NETGEAR M4100 Series ProSAFE

Switching Commands
113
M4100 Series ProSAFE Managed Switches
lacp actor port priority
Use this command to configure the priority value assigned to the Aggregation Port. The valid
range for <priority> is 0–255.
Note: This command is only applicable to physical interfaces.
no lacp actor port priority
Use this command to configure the default priority value assigned to the Aggregation Port.
lacp actor system priority
Use this command to configure the priority value associated with the LACP Actor’s
SystemID. The range for <priority> is 0–65535.
Note: This command is only applicable to physical interfaces.
no lacp actor system priority
Use this command to configure the priority value associated with the Actor’s SystemID.
Default 0x80
Format lacp actor port priority <priority>
Mode Interface Config
Format no lacp actor port priority
Mode Interface Config
Default 32768
Format lacp actor system priority <priority>
Mode Interface Config
Format no lacp actor system priority
Mode Interface Config