NETGEAR M4100 Series ProSAFE User Manual

Switching Commands
211
M4100 Series ProSAFE Managed Switches
MAC Database Commands
This section describes the commands you use to configure and view information about the
MAC databases.
bridge aging-time
This command configures the forwarding database address aging timeout in seconds. The
<seconds> parameter must be within the range of 10 to 1,000,000 seconds.
no bridge aging-time
This command sets the forwarding database address aging timeout to the default value.
SMACDMAC
Mode
May be enabled or disabled. The factory default is disabled.
TCP Flag Mode May be enabled or disabled. The factory default is disabled.
TCP FIN&URG&
PSH Mode
May be enabled or disabled. The factory default is disabled.
TCP Flag &
Sequence Mode
May be enabled or disabled. The factory default is disabled.
TCP SYN Mode May be enabled or disabled. The factory default is disabled.
TCP SYN & FIN
Mode
May be enabled or disabled. The factory default is disabled.
TCP Fragment
Mode
May be enabled or disabled. The factory default is disabled.
TCP Offset Mode May be enabled or disabled. The factory default is disabled.
Default 300
Format bridge aging-time <seconds>
Mode Global Config
Format no bridge aging-time
Mode Global Config
Term Definition

NETGEAR M4100 Series ProSAFE Specifications

General

Product Type	Managed Switch
Form Factor	Rack-mountable
Layer	Layer 2/Layer 3
Management	Web-based, CLI, SNMP
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1x
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	32°F to 122°F (0°C to 50°C)
Storage Temperature	-20° to 70° C (-4° to 158° F)
PoE Support	Yes (on select models)