Management Commands
468
M4100 Series ProSAFE Managed Switches
User Account Commands
This section describes the commands you use to add, manage, and delete system users.
The software has two default users: admin and guest. The admin user can view and
configure system settings, and the guest user can view settings.
Note: You cannot delete the admin user. There is only one user allowed with
read/write privileges. You can configure up to five read-only users on
the system.
username (Global Config)
Use this command to add a new user to the local user database. The default privilege level
is
1. Using the encrypted keyword allows the administrator to transfer local user passwords
between devices without having to know the passwords. When the password parameter is
used along with encrypted parameter, the password must be exactly 128 hexadecimal
characters in length. If the password strength feature is enabled, this command checks for
password strength and returns an appropriate error if it fails to meet the password strength
criteria. The optional override-complexity-check parameter disables the validation of
the password strength.
Session Time Total time this session has been connected.
Session Type Shows the type of session, which can be HTTP, HTTPS, telnet, serial, or SSH.
Format username <name> {password <password> [encrypted
[override-complexity-check] | level <level> [encrypted
[override-complexity-check]] | override-complexity-check]} | {level
<level> [override-complexity-check] password}
Mode Global Config
Term Definition
Name The name of the user, up to 32 characters.
Password The password for the users 8-64 characters. This value can be zero if the no
passwords min-length command has been executed. The special characters allowed
in the password include: ! # $ % & ' ( ) * + , - . / : ; < = > @ [ \ ] ^ _ ` { | } ~.
level Specifies the user level. If not specified, the privilege level is 1. Level 0 can be
assigned by a level 15 user to another user to suspend that user’s access. Range
0-15. Enter access level 1 for Read Access or 15 for Read/Write Access.
Field Definition
To Next Page
Loading...
Need help?
General
