Routing Commands
230
M4100 Series ProSAFE Managed Switches
no arp dynamicrenew
This command prevents dynamic ARP entries from renewing when they age out.
arp purge
This command causes the specified IP address to be removed from the ARP cache. Only
entries of type dynamic or gateway are affected by this command.
arp resptime
This command configures the ARP request response time-out.
The value for <seconds> is a valid positive integer, which represents the IP ARP entry
response time-out time in seconds. The range for <seconds> is between 1-10 seconds.
no arp resptime
This command configures the default ARP request response time-out.
arp retries
This command configures the ARP count of maximum request for retries.
The value for <retries> is an integer, which represents the maximum number of requests
for retries. The range for <retries> is an integer between 0-10 retries.
Format no arp dynamicrenew
Mode Privileged EXEC
Format arp purge <ipaddr>
Mode Privileged EXEC
Default 1
Format arp resptime <seconds>
Mode Global Config
Format no arp resptime
Mode Global Config
Default 4
Format arp retries <retries>
Mode Global Config
To Next Page
Loading...
Need help?
General
