NETGEAR M4100 Series ProSAFE

Quality of Service Commands
275
M4100 Series ProSAFE Managed Switches
no match class-map
This command removes from the specified class definition the set of match conditions
defined for another class.
The <refclassname> is the name of an existing DiffServ class
whose match conditions are being referenced by the specified class definition.
• Class-Map Config
• Ipv6-Class-Map Config
match cos
This command adds to the specified class definition a match condition for the Class of
Service value (the only tag in a single tagged packet or the first or outer 802.1Q tag of a
double VLAN tagged packet). The value might be from 0 to 7.
• Class-Map Config
• Ipv6-Class-Map Config
match secondary cos
This command adds to the specified class definition a match condition for the secondary
Class of Service value (the only tag in a single tagged packet or the first or outer 802.1Q tag
of a double VLAN tagged packet). The value might be from 0 to 7.
match ip6flowlbl
This command adds to the specified class definition a match condition based on the
IP6flowlbl of a packet. The <label> is the value to match in the Flow Label field of the IPv6
header (range 0-1048575).
match destination-address mac
This command adds to the specified class definition a match condition based on the
destination MAC address of a packet. The <macaddr> parameter is any layer 2 MAC
address formatted as six, two-digit hexadecimal numbers separated by colons (for example,
Format no match class-map <refclassname>
Mode
Default none
Format match cos <0-7>
Mode
Default none
Format match secondary-cos <0-7>
Mode
Class-Map Config
Format match ip6flowlbl <label>
Mode Ipv6-Class-Map Configuration mode