NETGEAR M4100 Series ProSAFE User Manual

Routing Commands
239
M4100 Series ProSAFE Managed Switches
no ip route distance
This command sets the default static route preference value in the router. Lower route
preference values are preferred when determining the best route.
ip netdirbcast
This command enables the forwarding of network-directed broadcasts. When enabled,
network directed broadcasts are forwarded. When disabled they are dropped.
no ip netdirbcast
This command disables the forwarding of network-directed broadcasts. When disabled,
network directed broadcasts are dropped.
ip mtu
This command sets the IP maximum transmission unit (MTU) on a routing interface. The IP
MTU is the size of the largest IP packet that can be transmitted on the interface without
fragmentation. The software currently does not fragment IP packets.
• Packets forwarded in hardware ignore the IP MTU.
• Packets forwarded in software are dropped if they exceed the IP MTU of the outgoing
interface.
Packets originated on the router, such as OSPF packets, might be fragmented by the IP
stack. The IP stack uses its default IP MTU and ignores the value set using the ip mtu
command.
Default 1
Format ip route distance <1-255>
Mode Global Config
Format no ip route distance
Mode Global Config
Default disabled
Format ip netdirbcast
Mode Interface Config
Format no ip netdirbcast
Mode Interface Config

NETGEAR M4100 Series ProSAFE Specifications

General

Product Type	Managed Switch
Form Factor	Rack-mountable
Layer	Layer 2/Layer 3
Management	Web-based, CLI, SNMP
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1x
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	32°F to 122°F (0°C to 50°C)
Storage Temperature	-20° to 70° C (-4° to 158° F)
PoE Support	Yes (on select models)