NETGEAR M4100 Series ProSAFE User Manual

Management Commands
455
M4100 Series ProSAFE Managed Switches
no telnetcon maxsessions
Use this command to set the maximum number of Telnet connection sessions that can be
established to the default value.
telnetcon timeout
Use this command to set the Telnet connection session time-out value, in minutes. A session
is active as long as the session has not been idle for the value set. The time is a decimal
value from 1 to 160.
Note: When you change the time-out value, the new value is applied to all
active and inactive sessions immediately. Any sessions that have
been idle longer than the new time-out value are disconnected
immediately.
no telnetcon timeout
Use this command to set the Telnet connection session timeout value to the default.
Note: Changing the time-out value for active sessions does not become
effective until the session is reaccessed. Also, any keystroke activates
the new time-out duration.
Format no telnetcon maxsessions
Mode Privileged EXEC
Default 5
Format telnetcon timeout <1-160>
Mode Privileged EXEC
Format no telnetcon timeout
Mode Privileged EXEC

NETGEAR M4100 Series ProSAFE Specifications

General

Product Type	Managed Switch
Form Factor	Rack-mountable
Layer	Layer 2/Layer 3
Management	Web-based, CLI, SNMP
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1x
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	32°F to 122°F (0°C to 50°C)
Storage Temperature	-20° to 70° C (-4° to 158° F)
PoE Support	Yes (on select models)