Management Commands
452
M4100 Series ProSAFE Managed Switches
Telnet Commands
This section describes the commands you use to configure and view Telnet settings. You can
use Telnet to manage the device from a remote management host.
ip telnet server enable
Use this command to enable Telnet connections to the system and to enable the Telnet
Server Admin Mode. This command opens the Telnet listening port.
no ip telnet server enable
Use this command to disable Telnet access to the system and to disable the Telnet Server
Admin Mode. This command closes the Telnet listening port and disconnects all open Telnet
sessions.
telnet
Use this command to establish a new outbound Telnet connection to a remote host. The host
must be a valid IP address or host name. The value for <port> is a valid decimal integer in
the range of 0–65,535, where the default value is 23. If the optional debug parameter is
used, the current Telnet options enabled is displayed. The optional line parameter sets the
outbound Telnet operational mode as linemode (by default, the operational mode is character
mode). The optional noecho parameter disables local echo.
• Privileged EXEC
• User EXEC
Stop Bits The number of Stop bits per character. The number of Stop bits is always 1.
Parity
Type The parity method used on the serial port. The parity method is always None.
Default enabled
Format ip telnet server enable
Mode Privileged EXEC
Format no ip telnet server enable
Mode Privileged EXEC
Format telnet {<ip-address> | <hostname>} <port> [debug] [line] [noecho]
Modes
Term Definition
To Next Page
Loading...
Need help?
General
