Management Commands
502
M4100 Series ProSAFE Managed Switches
no radius accounting mode
Use this command to set the RADIUS accounting function to the default value (disabled).
radius server attribute
Use this command to specify the RADIUS client to use the NAS-IP Address attribute in the
RADIUS requests. If the specific IP address is configured while enabling this attribute, the
RADIUS client uses that IP address while sending NAS-IP-Address attribute in RADIUS
communication.
no radius server attribute
Use this command to disable the NAS-IP-Address attribute global parameter for RADIUS
client. When this parameter is disabled, the RADIUS client does not send the
NAS-IP-Address attribute in RADIUS requests.
Command example:
(NETGEAR Switch) (Config) #radius server attribute 4 192.168.37.60
Command example:
(NETGEAR Switch) (Config) #radius server attribute 4
radius server host
This command configures the IP address or DNS name to use for communicating with the
RADIUS server of a selected server type. While configuring the IP address or DNS name for
the authenticating or accounting servers, you can also configure the port number and server
name. If the authenticating and accounting servers are configured without a name, the
command uses the Default_RADIUS_Auth_Server and Default_RADIUS_Acct_Server as the
Format no radius accounting mode
Mode Global Config
Format radius server attribute 4 [<ipaddr>]
Mode Global Config
Parameter Definition
4 NAS-IP-Address attribute to be used in RADIUS requests.
ipaddr The IP address of the server.
Format no radius server attribute 4 [<ipaddr>]
Mode Global Config
To Next Page
Loading...
Need help?
General
