NETGEAR M4100 Series ProSAFE User Manual

Utility Commands
386
M4100 Series ProSAFE Managed Switches
no lease
This command restores the default value of the lease time for DHCP Server.
network (DHCP Pool Config)
Use this command to configure the subnet number and mask for a DHCP address pool on
the server. Network-number is a valid IP address, made up of four decimal bytes ranging
from 0 to 255. IP address 0.0.0.0 is invalid. Mask is the IP subnet mask for the specified
address pool. The prefix-length is an integer from 0 to 32.
no network
This command removes the subnet number and mask.
bootfile
The command specifies the name of the default boot image for a DHCP client. The
<filename> specifies the boot image file.
Default 1 (day)
Format lease [{<days> [<hours>] [<minutes>] | infinite}]
Mode DHCP Pool Config
Format no lease
Mode DHCP Pool Config
Default none
Format network <networknumber> [<mask> | <prefixlength>]
Mode DHCP Pool Config
Format no network
Mode DHCP Pool Config
Format bootfile <filename>
Mode DHCP Pool Config

NETGEAR M4100 Series ProSAFE Specifications

General

Product Type	Managed Switch
Form Factor	Rack-mountable
Layer	Layer 2/Layer 3
Management	Web-based, CLI, SNMP
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1x
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	32°F to 122°F (0°C to 50°C)
Storage Temperature	-20° to 70° C (-4° to 158° F)
PoE Support	Yes (on select models)