Quality of Service Commands
297
M4100 Series ProSAFE Managed Switches
show mac access-lists
This command displays a MAC access list and all of the rules that are defined for the MAC
ACL. Use the [<name>] parameter to identify a specific MAC ACL to display.
IP Access Control List (ACL) Commands
This section describes the commands you use to configure IP ACL settings. IP ACLs ensure
that only authorized users have access to specific resources and block any unwarranted
attempts to reach network resources.
The following rules apply to IP ACLs:
• Managed switch software does not support IP ACL configuration for IP packet fragments.
• The maximum number of ACLs you can create is hardware-dependent. The limit applies
to all ACLs, regardless of type.
• The maximum number of rules per IP ACL is hardware-dependent.
Format show mac access-lists [<name>]
Mode Privileged EXEC
Term Definition
Rule Number The ordered rule number identifier defined within the MAC ACL.
Action The action associated with each rule. The possible values are Permit or Deny.
Source MAC
Address
The source MAC address for this rule.
Destination MAC
Address
The destination MAC address for this rule.
Ethertype The Ethertype keyword or custom value for this rule.
VLAN ID The VLAN identifier value or range for this rule.
COS The COS (802.1p) value for this rule.
Log Displays when you enable logging for the rule.
Assign Queue The queue identifier to which packets matching this rule are assigned.
Mirror Interface The slot/port to which packets matching this rule are copied.
Redirect
Interface
The slot/port to which packets matching this rule are forwarded.
Time Range
name
Displays the name of the time-range if the MAC ACL rule has referenced a time range.
Rule Status Status (Active/Inactive) of the MAC ACL rule
To Next Page
Loading...
Need help?
General
