NETGEAR M4100 Series ProSAFE

Switching Commands
48
M4100 Series ProSAFE Managed Switches
vlan ingressfilter
This command enables ingress filtering. If ingress filtering is disabled, frames received with
VLAN IDs that do not match the VLAN membership of the receiving interface are admitted
and forwarded to ports that are members of that VLAN.
no vlan ingressfilter
This command disables ingress filtering. If ingress filtering is disabled, frames received with
VLAN IDs that do not match the VLAN membership of the receiving interface are admitted
and forwarded to ports that are members of that VLAN.
vlan makestatic
This command changes a dynamically created VLAN (one that is created by GVRP
registration) to a static VLAN (one that is permanently configured and defined). The ID is a
valid VLAN identification number. VLAN range is 2-4093.
vlan name
This command changes the name of a VLAN. The name is an alphanumeric string of up to 32
characters, and the ID is a valid VLAN identification number. ID range is 1-4093.
• VLAN ID 1 - default
• other VLANS - blank string
no vlan name
This command sets the name of a VLAN to a blank string.
Default disabled
Format vlan ingressfilter
Mode Interface Config
Format no vlan ingressfilter
Mode Interface Config
Format vlan makestatic <2-4093>
Mode VLAN Config
Default
Format vlan name <1-4093> <name>
Mode
VLAN Config
Format no vlan name <1-4093>
Mode VLAN Config